[PCB_FORUM] Re: Capture CIS globally replace symbol

Hey Dave,

Thanks for the advice, I'll give that a try.  They will not allow
"quick and dirty", so I'll have to replace them one way or another.

Regards,
 
Gary E. MacIndoe
PCB Design Engineer
Advanced Micro Devices
Longmont, Colorado
 
amd.com
gary.macindoe@xxxxxxx

-----Original Message-----
From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Dave Schaefer
Sent: Tuesday, December 12, 2006 6:16 PM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Re: Capture CIS globally replace symbol

Gary,

I believe you can use "replace cache" at the design level... have a look

in the Capture help section for details.

There's also the quick and dirty method - draw both GND symbols and 
connect with a trace !!

Dave

Macindoe, Gary wrote:
>
> Hey guys,
>
> I am helping with the cleanup of a set of schematics in Capture CIS. 
> The set consists of pages from a few sources.
>
> There are "gnd" symbols from two sources, one good and the other bad. 
> I would like to globally replace the bad ones
>
> with the good ones. I could do it manually symbol by symbol, page by 
> page...ugh! I was hoping someone knew how to
>
> accomplish this globally.
>
> Thanks for any help!
>
> Regards,
>
> Gary
>
> * *
>
> * Gary E. MacIndoe *
>
> PCB Design Engineer
>
> Longmont , Colorado
>
> amd.com
>
> gary.macindoe@xxxxxxx
>
-----------------------------------------------------------
To subscribe/unsubscribe: 
Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe

To view the archives of this list go to
http://www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------




-----------------------------------------------------------
To subscribe/unsubscribe: 
Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe

To view the archives of this list go to 
http://www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------

Other related posts: