[PCB_FORUM] Re: Capture CIS globally replace symbol

Gary,
I believe you can use "replace cache" at the design level... have a look in the Capture help section for details.
There's also the quick and dirty method - draw both GND symbols and connect with a trace !! 

Dave

Macindoe, Gary wrote:


Hey guys,
I am helping with the cleanup of a set of schematics in Capture CIS. The set consists of pages from a few sources.
There are “gnd” symbols from two sources, one good and the other bad. I would like to globally replace the bad ones
with the good ones. I could do it manually symbol by symbol, page by page…ugh! I was hoping someone knew how to 

accomplish this globally.

Thanks for any help!

Regards,

Gary

* *

* Gary E. MacIndoe *

PCB Design Engineer

Longmont , Colorado

amd.com

gary.macindoe@xxxxxxx


-----------------------------------------------------------
To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx 
with a subject of subscribe or unsubscribe

To view the archives of this list go to 
http://www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
-----------------------------------------------------------

Other related posts: