If you did NOT filter out the via and pins, you will be there a loooong time. The holes in padstacks take an extremely long time to process in Pro/E. Regards, Charlie -----Original Message----- From: icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Ooi, Ching Leong Sent: Friday, December 01, 2006 4:53 AM To: icu-pcb-forum@xxxxxxxxxxxxx Subject: [PCB_FORUM] Cadence to Pro-E Hi experts,, I am pretty new to Pro-E, A simple and quick question, importing into Pro-E using emn/emp file out from Cadence, does it normally take long ? Say for a normal motherboard file ~1k components ? My clock is 1 hour+ and counting, just want to make sure worth waiting and not because the program has crashed and hang there... Thank you CL ----------------------------------------------------------- To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx with a subject of subscribe or unsubscribe To view the archives of this list go to //www.freelists.org/archives/icu-pcb-forum/ Problems or Questions: Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx ----------------------------------------------------------- ----------------------------------------------------------- To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx with a subject of subscribe or unsubscribe To view the archives of this list go to //www.freelists.org/archives/icu-pcb-forum/ Problems or Questions: Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx -----------------------------------------------------------