Hi Carl If you've got an expert seat then pin delay can be used for this. Best Regards David Greig ______________________________ GigaDyne Ltd http://www.gigadyne.co.uk ______________________________ -----Original Message----- From: icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Austin Franklin Sent: 2005-June-30 16:35 To: icu-pcb-forum@xxxxxxxxxxxxx Subject: [PCB_FORUM] Re: [BULK] - Differential Pairs on 15.2 Hi Carl, > Has anyone had to deal with differential pairs in 15.2 that are not > balanced out of the IC. The Mellanox > InfiniHost_III_MT25208 spec that the PCIX bus diff pairs are not > balanced out the chip and give the skews and states that the skew must > be accounted for on the PC layout to balance the pair completely end > to end. How would I configure this rule in allegro? For instance is > there a way to tell the tool to route the + end 50 mils longer than - > end? Can't you set-up a match length group for the pair and use "delta" on one of the legs and then the "tolerance" to 0 (or something small)? Regards, Austin ----------------------------------------------------------- To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx with a subject of subscribe or unsubscribe To view the archives of this list please login at //www.freelists.org. Our list name is icu-pcb-forum or go to //www.freelists.org/archives/icu-pcb-forum/ Problems or Questions: Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx Want to post a job listing ? DON'T DO IT HERE! Better yet, join our jobs listing forum. SUBSCRIBE: icu-jobs-forum-subscribe@xxxxxxxxxx POST: icu-jobs-forum@xxxxxxxxxx ----------------------------------------------------------- -- Virus scanned by Lumison. ----------------------------------------------------------- To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx with a subject of subscribe or unsubscribe To view the archives of this list please login at //www.freelists.org. Our list name is icu-pcb-forum or go to //www.freelists.org/archives/icu-pcb-forum/ Problems or Questions: Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx Want to post a job listing ? DON'T DO IT HERE! Better yet, join our jobs listing forum. SUBSCRIBE: icu-jobs-forum-subscribe@xxxxxxxxxx POST: icu-jobs-forum@xxxxxxxxxx -----------------------------------------------------------