[PCB_FORUM] Re: Assign Color
- From: "Schwartz, Jerome" <jschwa01@xxxxxxxxxx>
- To: <icu-pcb-forum@xxxxxxxxxxxxx>
- Date: Mon, 5 Oct 2009 15:43:04 -0400
Gary,
Check if your temporary highlight color is BLACK.
Jerry
________________________________
From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Dickoff, Diane
J
Sent: Monday, October 05, 2009 3:26 PM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Re: Assign Color
When I slide, I actually lose the entire net....I have to guess where it
is sliding. I am using opengl and assumed it was because of that.
I highlight my different byte lanes.
Diane.
________________________________
From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Gary MacIndoe
Sent: Monday, October 05, 2009 12:15 PM
To: icu-pcb-forum
Subject: [PCB_FORUM] Assign Color
Hey guys,
Anyone use the Assign Color function and get bad results?
When routing/matching a DDR memory interface, I like to have different
colors for the byte lanes, strobe and clock pairs.
While routing/sliding the colored traces, most of the time trace
segments lose their color.
Anyone else see this? Know of a way to prevent it?
Thanks for any help!
Regards,
Gary MacIndoe
gemcad@xxxxx
Other related posts:
