Hi Gerry, In Capture make sure you have Intertool Communication enabled in the Preferences>Miscellaneous(tab). Then I would create an allegro pst netlist and selecting netrev to board file. or re-read in the netlist into the board file. In Allegro you must select highlight to enable. Best regards, -oscar On Mon, Jul 18, 2011 at 6:10 AM, Gerry Meier <gerry.meier@xxxxxxxxxxxxxx>wrote: > I am using Ver 16.3 and just setup a new computer. I have transferred my > env file and all user preferences. **** > > For some reason I can only cross probe from Allegro to Capture but not back > from Capture to Allegro.**** > > Others can do both using the same board file and schematic.**** > > I have removed all my preferences and just used the defaults and still > same result.**** > > I have re-installed ver 16.3 and the latest ISR – same result**** > > ** ** > > Anyone have this problem and was able to fix it?**** > > ** ** > > Thanks,**** > > Gerry**** > > ** ** > > Gerry Meier, Sr. PCB Designer**** > > Freedom CAD Services. Inc**** > > Voice: (256) 715-1424 or (603) 864-1350**** > > Email:gerry.meier@xxxxxxxxxxxxxx**** > > Skype: rgmeier3**** > > visit us at http://www.freedomcad.com**** > > *P** ** Think Green only print as needed*. **** > > ** ** >