Hi, This system is relatively new, it's an athlon 1.4 ghz, with 512 ddr ram. I compared the lilo.conf files of the mandrake install, and the redhat install. The following are in the mandrake install The differences were: vga=normal <- i knew this didn't make a difference keytable=/boot/us.klt <- figured it was keymapping nowarn <- no idea what this is ignore-table <- no idea what this is now in the linux label part redhat didn't contain append="quiet devfs=mount hdb=ide-scsi" it had append="hdb=ide-scsi" Those are the only differences other than the timeout part, they both contained "lba32" as well. Still no luck. I never did add the append="quiet devfs=mount". I wasn't sure what that was. Any ideas? >From: "J.R. Wessels" <jwessels@xxxxxxxxxxx> >Reply-To: huskerlug@xxxxxxxxxxxxx >To: huskerlug@xxxxxxxxxxxxx >Subject: [huskerlug] Re: Serious hard drive/boot loader problems! (LONG) >Date: Wed, 7 Aug 2002 13:07:12 -0500 > > >I had that problem with the LI showing up, but only on older systems. To >fix >it, I told Lilo to work with the drive in linear mode, not lbr. That was >by >adding this line in the lilo.conf file.... > >linear > _________________________________________________________________ Send and receive Hotmail on your mobile device: http://mobile.msn.com ---- Husker Linux Users Group mailing list To unsubscribe, send a message to huskerlug-request@xxxxxxxxxxxxx with a subject of UNSUBSCRIBE