Create a GPO and in the Security Filtering section ("Scope" tab in GPMC) replace "Authenticated Users" with your group name. Then just link it to your domain or top-level OU and you should be good to go. Regards, Jamie Nelson -----Original Message----- From: gptalk-bounce@xxxxxxxxxxxxx [mailto:gptalk-bounce@xxxxxxxxxxxxx] On Behalf Of Paul Snell Sent: Wednesday, October 24, 2007 11:30 AM To: gptalk@xxxxxxxxxxxxx Subject: [gptalk] Deploying Software One of our scripters has created a set of .cmd files that install software using a customised template. If I try to run these from a command line I get an error message saying that it can't use UNC paths, but then starts the installation. I want to add these scripts to a GPO so that the software only gets installed to specific pcs. I have created a group that contains the pcs that need to have the software installed. What is the best way to deploy? *********************** You can unsubscribe from gptalk by sending email to gptalk-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field OR by logging into the freelists.org Web interface. Archives for the list are available at //www.freelists.org/archives/gptalk/ ************************