John, I've come up with a few occasions when the blue tooth receiver is appearing in the connectivity menu, i.e. O cord C B but when I go in to the GPS software it can't find the receiver. The only option that appears to work for me is to remove the pairing and then reconnect things. To remove the pairing, turn the receiver off. Do O cord, C, B, enter y for blue tooth on, N for don't search for Bluetooth devices. Go down the list of devices to the right one, enter on it and hit R for remove pairing. Now turn the receiver on, and repeat the above, but obviously say yes to search for blue tooth devices. If this doesn't work then I do a reset which is to hold the two recessed buttons down on the right side of the PK keyboard. I think they are called C3 and C4. After a few seconds you get a reboot of the system. This will turn the blue tooth off as well. To be honest I find that once you have the system going then simply just don't turn anything off. Carry the spare battery for the GPS though just in case. A light probe to check the lights on the receiver is also a must. Nine times out of ten you can rely on the PK to say if the receiver is on or not but if you miss it then it takes a while to work through all the combinations to get the thing up and running again. And of course it happens when you need it fastest. The blue logger is OK on buses if you sit on the right hand side and hold it up against the window about eighteen inches up. The best position seems to be on the rear seat of the bus but of course you have to put up with the eccentrics that hang out back there. Twelve year olds swapping drug tips and comparing knives being just one episode I had recently. -----Original Message----- From: gps-talkusers-bounce@xxxxxxxxxxxxx [mailto:gps-talkusers-bounce@xxxxxxxxxxxxx] On Behalf Of John Gallagher Sent: 28 April 2005 17:07 To: gps-talkusers-freelists.org Subject: [gps-talkusers] brilliant Hi list, Must make a comment about my pk gps which I acquired to-day. it's really brilliant. much faster with acquiring routes and faster when responding to commands. a real plus what a brilliant job. I did try my other gps btgps receiver which the pk will pair with and say active sync is active but when I run the gps it cannot use the receiver no worry as on the top of my pc in the bedroom I get seven satellites. Wonder if Liam is on the list as when I connected my blue logger it took some time to get the gps program to see the logger. Liam, if you are on the bus and loose touch with the gps receiver what do you do? I mean what re-set do you perform to get the receiver back again. e.g. if on abbeydale road and you have to tune a piano at Cartanole road you need the receiver on fast as you can as you may pass cartanole road. not sure which re-set to do and if you must pair again from scratch. sorry about the nature of this post but tomorrow I have tunings to do and must try and find this out. thanks.