Dear all, First a note of thanks for all those who helped me with the e-mailing of system messages from my Unix system - much appreciated! All resolved and she's working a treat! A new one: I have a P81 machine which, for reasons I really can't figure out, stops dead at the Forth toolkit prompt, it needs a " boot disk" command to get it to carry on. Once that is done - all appears well until the next reboot, when we get stuck at the prompt again. This happened once before on an old AW51B box, but I did not pay it much attention since it was on a hot spares cabinet in the technical workshop and it is now "advantage upgraded". Is this an EPROM issue, a problem with the software on the hard disk or is it a hardware problem. Advice I received is to purchase a new machine and this is, to my mind, NOT a satisfactory solution. Hope to hear from others with a similar experience? Take care, > Anton Prinsloo > Control System Superintendent > Zinifex Century Mine > Tel: +61 (07) 4769 5762 > Mob: +61 (0) 423 608 734 > Fax: +61 (07) 4769 5764 > Email: anton.prinsloo@xxxxxxxxxxx > > _______________________________________________________________________ This mailing list is neither sponsored nor endorsed by Invensys Process Systems (formerly The Foxboro Company). Use the info you obtain here at your own risks. Read http://www.thecassandraproject.org/disclaimer.html foxboro mailing list: //www.freelists.org/list/foxboro to subscribe: mailto:foxboro-request@xxxxxxxxxxxxx?subject=join to unsubscribe: mailto:foxboro-request@xxxxxxxxxxxxx?subject=leave