Hi folks, I cannot put my hands on my integrator references at the moment, can anyone decipher the settings in the primary ECB and tell me how it's setup. We are planning on replacing the current PLC with another device and I want to preset the communication settings. Here are the ECB parameters: COMPND BLOCK TYPE DESCRP NRBUS BUSOPT BUSTYP PIOWDT MPOLL BAUD DATBIT PARITY STPBIT MG30GW_ECB PRIMARY_ECB ECBPG 1 1 3 3 7 3 8 2 1 Regards, Ken Moore Process Controls Specialist Celanese NOTE: The information transmitted is intended only for the person or entity to which it is addressed and may contain confidential and/or privileged material. Any review, retransmission, dissemination or other use of, or taking of any action in reliance upon this information by persons or entities other than the intended recipient is prohibited. If you received this in error, please contact the sender and delete the material from any computer. _______________________________________________________________________ This mailing list is neither sponsored nor endorsed by Invensys Process Systems (formerly The Foxboro Company). Use the info you obtain here at your own risks. Read http://www.thecassandraproject.org/disclaimer.html foxboro mailing list: //www.freelists.org/list/foxboro to subscribe: mailto:foxboro-request@xxxxxxxxxxxxx?subject=join to unsubscribe: mailto:foxboro-request@xxxxxxxxxxxxx?subject=leave