Jack, The question is not related to write protection of factory templates. - Peter -----Original Message----- From: duxhelp-bounce@xxxxxxxxxxxxx [mailto:duxhelp-bounce@xxxxxxxxxxxxx] On Behalf Of Jack Maartman Sent: Tuesday, March 22, 2005 4:21 PM To: duxhelp@xxxxxxxxxxxxx Subject: [duxhelp] Re: Embosser Setup (again) Does this have anything to do with factory templates being write protected. I personally am glad, when experimenting embosser configurations to find them in the custom templates I have created. I don't see how this could change unless document settings were stored somewhere else, and that would seem to make things rather complicated. Jack t know if this of much value, but nevertheless * * * * This message is via list duxhelp at freelists.org. * To unsubscribe, send a blank message with * unsubscribe * as the subject to <duxhelp-request@xxxxxxxxxxxxx>. You may also * subscribe, unsubscribe, and set vacation mode and other subscription * options by visiting //www.freelists.org. The list archive * is also located there. * Duxbury Systems' web site is http://www.duxburysystems.com * * *