[duxhelp] Re: Embosser Setup (again)
- From: "Peter Sullivan" <peter@xxxxxxxxxx>
- To: <duxhelp@xxxxxxxxxxxxx>
- Date: Wed, 23 Mar 2005 11:34:16 -0500
Jack,
The issue is simply whether, as now, templates should contain document
dimension and target embosser information.
- Peter
-----Original Message-----
From: duxhelp-bounce@xxxxxxxxxxxxx [mailto:duxhelp-bounce@xxxxxxxxxxxxx] On
Behalf Of Jack Maartman
Sent: Tuesday, March 22, 2005 7:00 PM
To: duxhelp@xxxxxxxxxxxxx
Subject: [duxhelp] Re: Embosser Setup (again)
Hi Peter:
I am afraid, I am not grasping this issue well. I am trying to extrapolate
the problem from the list, You probably, I would think have enough on your
plate right now, to have the time to summarize the problem. And in fact I
may, in fact, have very little to add. I had to set up many configurations
until I found one that worked for me, that is sending a file through a
serial port to the braille lite as if it were an embosser. The one that
works best for me is printing directly to a file. and utilizing this. I
thought I had overwritten these settings, but was pleased to find the
settings attached to a template.
Sorry if I am inundating the list with too much traffic.
Cheers
Jack
* * *
* This message is via list duxhelp at freelists.org.
* To unsubscribe, send a blank message with
* unsubscribe
* as the subject to <duxhelp-request@xxxxxxxxxxxxx>. You may also
* subscribe, unsubscribe, and set vacation mode and other subscription
* options by visiting //www.freelists.org. The list archive
* is also located there.
* Duxbury Systems' web site is http://www.duxburysystems.com
* * *
Other related posts:
