I cannot find anything in the CT user manual that describes how to
make automation relative rather than absolute.
So here's the scenario:
I use automation during mixdown for let's say volume on a track.
The result is great but here's the issue.
I decide a bit later on in the mix of that tune that I need to
increase the volume on the automated track for the whole track.
Can't do it. I have to scratch the automation and start over. real
pain in the butt.
I'm looking for a way to be able to change the volume relative to
other tracks without disturbing the automation.
Tracks are audio only.
Any ideas,
thanks,
Floyd...
PLEASE READ THIS FOOTER AT LEAST ONCE!
To leave the list, click on the immediately following link:
ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe
If this link doesn't work then send a message to:
ddots-l-request@xxxxxxxxxxxxx
and in the Subject line type
unsubscribe
For other list commands such as vacation mode,
click on the immediately following link:
ddots-l-request@xxxxxxxxxxxxx?subject=faq or
send a message, to
ddots-l-request@xxxxxxxxxxxxx
and in the Subject line type
faq
