No worries. I can access everything except for the parameters that are specific to the audio effect I have patched. So, I can access the eq parameters, and I can access the generic controller parameters, like controller 11, controller 74, etc. Just can't get at the ones specific to Waves or any other patched effect. It just says attack, or release, and nothing else. Hopefully someone will have some suggestions. Thanks again, On Nov 25, 2010, at 11:34 PM, Chris Smart wrote: > OH ok, I get it now. > So, you can't even access Sonar's track EQ parameters in the inspector? > > I'm not sure what to suggest as i haven't seen that happen on my system. > Hopefully someone else has an idea or two. > > Chris > > PLEASE READ THIS FOOTER AT LEAST ONCE! > To leave the list, click on the immediately following link: > ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe > If this link doesn't work then send a message to: > ddots-l-request@xxxxxxxxxxxxx > and in the Subject line type > unsubscribe > For other list commands such as vacation mode, click on the immediately > following link: > ddots-l-request@xxxxxxxxxxxxx?subject=faq or > send a message, to ddots-l-request@xxxxxxxxxxxxx > and in the Subject line type > faq > > PLEASE READ THIS FOOTER AT LEAST ONCE! To leave the list, click on the immediately following link: ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe If this link doesn't work then send a message to: ddots-l-request@xxxxxxxxxxxxx and in the Subject line type unsubscribe For other list commands such as vacation mode, click on the immediately following link: ddots-l-request@xxxxxxxxxxxxx?subjectúq or send a message, to ddots-l-request@xxxxxxxxxxxxx and in the Subject line type faq