Hi all. I would like to have some information about how to obtain the best from targen when you have to profile an RGB printer (-d2). I tried some parameters but, in the final profile, I noticed no big differences using the same number of patches. I'd like to have a total of 1500/1700 patches. I would like to know: 1) Are you using the -G (Incremental Far Point Distribution from fast to good) parameter? Did you notice any differences between with or without -G? In my (small) experience -G is not giving me better results. Do you suggest to use it anyway? 2) How many white patch are you using? I tried to set -e at more than the default value (for example 8 instead of 4) but also in this case I could not notice differences in the final profile. 3) I was trying the -g parameter to set some (64) patches with same RGB values. Is this helpfull to improve the BW neutrality or not? Do you use this paramter when you are genereting a target that will be used to make a RGB printer profile? Thanks. Vittorio