you can make your own profile. i recommend using "density" only On 9/3/11, adam k <aak1946@xxxxxxxxx> wrote: > Hello, > I would like to calibrate my R1800 for use with Printphoto program. I would > like to use Colormunki to calibrate printer, but I'm not sure how to print > Colormunki > targets using guttenprint driver. Is it possible? If yes, how? > I understand that profiles created using Epson drivers are not good in > guttenprint. Right? > Thank you! > > -- > Adam Kielcz > > Note: If you forward this email, please delete the forwarding > history, which includes my email address and any others you see in > this email. It is a courtesy to me and others who may not wish to have > their email addresses sent all over the world. Erasing the history > also helps prevent Spammers from gathering addresses and prevents > viruses from being sent to your friends and mine. > --------------------------------------------------------------------------------------- > No trees were harmed in the posting of this message . . . however an > extraordinarily large number of electrons were horribly > inconvenienced. >