[argyllcms] Failure to profile printer using colormunki
- From: Richard Hughes <hughsient@xxxxxxxxx>
- To: argyllcms@xxxxxxxxxxxxx
- Date: Mon, 22 Feb 2010 23:14:54 +0000
Using the 1.1.1 binaries from the argyll website:
[hughsie@hughsie-work bin]$ ./printtarg -v -i CM -h -t 300 -p A4 test
Paper chosen is A4 [210.0 x 297.0 mm]
Patches = 210
Test patches per row = 15
Rows per page = 14, patches per page = 210
Rows in last strip = 14, patches in last row = 15
Total pages needed = 1
Worst case delta E = 17.561729
Worst case direction distinction delta E = 66.114449
Optimising layout for strip reader:
100%
After optimisation, worst delta E = 89.305150
Worst case direction distinction delta E = 85.458963
Creating file 'test.tif'
[hughsie@hughsie-work bin]$ ./chartread -v test
Steps in each Pass = 15
Passes in each Strip = 14
Instrument Type: ColorMunki
Serial Number: 2023111
Firmware version: 288
Chip ID: 01-52706812000099
Version string: 'colormunki FW V1.32 Build Nr. 1303'
Calibration Ver.: 6
Production No.: 37357
Set instrument sensor to calibration position,
and then hit any key to continue,
or hit Esc or Q to abort:
Calibration failed with 'Measurement misread' (White reference
calibration didn't converge)
Hit any key to retry, or Esc or Q to abort:
Calibration failed with 'Measurement misread' (White reference
calibration didn't converge)
Hit any key to retry, or Esc or Q to abort:
I can't seem to get the ColorMunki to self calibrate when using
chartread, but it seems to work just fine when I'm using dispcal to
calibrate the screen.
Ideas welcome. Thanks.
Richard.
Other related posts:
