[arachne] Re: ssh2dos ???

Arachne at FreeLists---The Arachne Fan Club!

On Fri, 12 Jun 2009 18:58:45 +0100, Bastiaan Edelman wrote:

> On Thu, 11 Jun 2009 20:02:53 -0500, Glenn McCorkle wrote:

>> Arachne at FreeLists---The Arachne Fan Club!

>> On Fri, 12 Jun 2009 01:05:57 +0100, Bastiaan Edelman wrote:

>>> On Wed, 10 Jun 2009 16:35:40 -0500, Glenn McCorkle wrote:

>>> <snip>

>>> Perhaps you could run it for some more time...
>>> I tested it, but...

>>> 75.24.13.157
>>> username = freelists
>>> password = arachne

>>> All attempt (config-file/DHCP/BOOTP/RARP) to get a IP-address failed.
>>> Check your configuration.

>>> I think that config file is my problem. Found that file in SSH2DOS
>>> directory, but no idea what should be in that cfg file.

>> Let me have a look please, at this section of your working arachne.cfg

>> __________________________________

>> [tcp/ip]
>> IP_Address WATTCP
>> IP_Grab IP address set to
>> NameServer
>> AltNameServer
>> Gateway 0.0.0.0
>> AltGateway 0.0.0.0
>> Netmask 0.0.0.0
>> TCPconfig PPPTCP.CFG

>> _________________________________

> [tcp/ip]
> ;IP_Address BOOTP
> IP_Address 192.168.1.65    (this computer of mine)
> IP_Grab IP address set to
> NameServer 192.168.1.254   (port to internet via modem...
> AltNameServer 0.0.0.0       remember we made a special dialin mode
> Gateway 192.168.1.254       to trick out javascript)
> AltGateway 0.0.0.0
> Netmask 255.255.255.0
> TCPconfig LANTCP.CFG

> In LANTCP.CFG all entries like netmask, gateway, etc are commented out,
> exept:
> hostname = arachne
> sockdelay = 40
> mss = 1024

>> Also.... the file named in the 'TCPconfig line'

>> --- in my case... ppptcp.cfg ---

>> #my_ip= $(MYIP)
>> #my_ip=bootp
>> my_ip=dhcp      (this one commented out too)
>> sockdelay=60
>> hostname=arachne
>> mss=1600
>> #

>> _______________________________________

>> With that info.... we'll get ssh2dos & sshdos67 working.

> That would be very nice... Regards, Bastiaan


OK.... here's what you will need.

Make the following entries in wattcp.cfg
located in your arachne_main directory.

my_ip = 192.168.1.65
nameserver=192.168.1.254
gateway = 192.168.1.254
netmask = 255.255.255.0
sockdelay=60
hostname=arachne
mss=1600

__________________________________________________________


That should get you going with both  ssh2dos.apm & sshdos67.apm


-- 
 http://www.glennmcc.org/
                  Arachne at FreeLists                  
-- Arachne, The Premier GPL Web Browser/Suite for DOS --

Other related posts: