This message was posted by SkyLinePrints on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/ultimatebb.php?/topic/1/266.html#000003 if the thread is coming out and everything is ok, then we might not be having the same issue. couple of ideas to check. are the feed rollers worn or dirty? its possible the thread feed is off and pushing to much or not enough. Go to: Maintainence>Steppers look for thread feed. Test the thread feed to be sure its pushing 200mm forward and back. =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================