This message was posted by oldkush on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/cgi-bin/ultimatebb.cgi?/topic/1/869.html#000001 I don't know the size of your lettering or what you are stitching on but the problems you are experiencing are likely the result of improper digitizing. Generally speaking when creating small lettering ... 1) reduce stitch density considerably. Amount of reduction will depend on size of letters, material being stitched on, etc. 2) use only a center run underlay [or if very small letters, possibly no underlay at all] 3} choose your fonts carefully. Not all fonts stitch well when doing small lettering. 4) search for and remove excessively short stitches from lettering [especially if your thread breaks seem to occur in the same areas of the design] Good luck Bob =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================