David, I would also like to see what the design is doing. I am digitizing some designs tonight using 6.08.522 and would be happy to take a look at it for you too.... Rod Springer Embroidery Cottage Rod & Sharon Springer Melco Amaya Tech & Trainer Design Shop Pro+ Digitizing Boise, ID 83713 208-938-3038 ----- Original Message ----- From: <dsklar@xxxxxxxxxxx> To: <amayausers@xxxxxxxxxxxxx> Sent: Monday, March 06, 2006 5:30 PM Subject: [amayausers] Stitching not Following Digitizing >I created a design that has a right triangle at the bottom oriented such >that the right angle is at the top left corner with one side going down at >180 degrees, the other across to the right at 90 degrees and the hypotenuse >at an angle from the bottom left and rising to the top right. The triangle >is a fill with the entry point at the bottom corner and the exit at the >right hand corner (not the right angle). Then, a satin column border of >the same color is stitched along the hypotenuse. The column is digitized >to start right where the fill exits. I have verified this very carefully >in DesignShop Pro+ (6.08.522). However, when sewing, the Amaya starts at >the bottom left corner (like it should) but then exits at the right angle >(top left) rather than at the top right as digitized. This behavior forces >a trim when the machine should not stop at all. I have not had time to >play much with this yet. Is this a bug or a "feature"? Anyone experience >this? > > David Sklar > Ballyhoo! > Arlington, VA >