This message was posted by Juli in Kona on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/cgi-bin/ultimatebb.cgi?/topic/1/961.html#000002 Yeah, well I wish the job ran as smoothly! There were 10 letters of 2 colors ea. I finally just put in 4,1,4,1 etc to make a total of 20. BUT the last two letters had the opposite colors which I didn't notice until it was half way through the last color. So, I "moved" to color 18 and that was supposed to be needle 1, but started sewing with needle 4. I changed it manually and did that letter. Then - I don't know what I did - can't seem to hold a thought too long. Anyway I finished it. Had to use a colored pen to color some edges that were peeking out, but only I would know that. Looked good. What a relief! It was the customers material. This was manually digitized Goudy Stout letters that I then used the Shadow tool on. I think it has to do with that. Something screwed up. And at first it was giving me 30 colors before I did a lot of fooling around with it. If it was just my material that I could replace, I would have just gone ahead and tried it with 30 color changes. Never could figure out what it thought it was doing. But I am pretty sure it has to do with the Shadow tool. Juli =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================