This message was posted by cbireley on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/ultimatebb.php?/topic/2/910.html I just did some nylon pants w/the mesh lining, left placement logo. I pulled and made sure the mesh was flat and straight before I hooped, but there is still a pucker above the design. What can I do to prevent this, other than what I did? If I hold them , it all looks fine, but if they are on, the pucker is obvious....help! =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================