Hello, Greenwing has just posted in the Machines & Hardware forum of AmayaUsers Discussion Boards under the title of Laser Alignment. This thread is located at http://www.amayausers.com/discussion/showthread.php?5971-Laser-Alignment Here is the message that has just been posted: *************** you move to your first reference point using the hoop & arrow key combination. on the right then press the laser & the left arrow key together then move to the next position on the left and press the laser & left arrow together again Then press the laser & the center key and your design will center between the two points you just plotted. *************** =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================