XT, and yes, it trims usually. If I'm doing other things, using backing. But on the Redwork, even a really crisp tearaway can be difficult to remove. Did some of the Emb. library Jacobean Fruit designs too, "I bought 250 flour sack towels" and that wasn't trimming either. Then the thread doesn't trim either, crimps up, catches underneath, got so tight, it broke a needle. Susan Sent from my iPad > On Aug 16, 2014, at 3:40 PM, "AmayaUsers Discussion Boards" > <theboards@xxxxxxxxxxxxxx> wrote: > > > Hello, > > levelbest has just posted in the Machines & Hardware forum of AmayaUsers > Discussion Boards under the title of Bobbin thread not trimming. > > This thread is located at > http://www.amayausers.com/discussion/showthread.php?5864-Bobbin-thread-not-trimming > > Here is the message that has just been posted: > *************** > Machine type? Big red or XT/XTS? > > You didn't mention - if you run the same designs or other designs on standard > material on the same machine with backing - does it trim every time them? > *************** > > =========================================================== > > The AmayaUsers Mailing List > Website: http://www.amayausers.com > Discussion Board: http://www.amayausers.com/boards > Subscribe/Unsubscribe: http://www.amayausers.com/list > > =========================================================== > ========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list =========================================================