Hello, Greenwing has just posted in the Machines & Hardware forum of AmayaUsers Discussion Boards under the title of XTS - Disillusioned. This thread is located at http://www.amayausers.com/discussion/showthread.php?5774-XTS-Disillusioned Here is the message that has just been posted: *************** I am sure your using a design you used before.. But about the density in the brother software the density of 5 or 4.5 means the # of threads per MM and 114 would mean the Same in inches. in the Design shop software they use points that is 100th of an inch. and the # has nothing to do with the thread. it represents the SPACE between the needle points so a density of 3.8 or 4 is a fill density. and a 20 or 30 so would be an underlay. It was very hard for me when I made the transition. In Design shop a density of 1 will break needles in PeDesign a density of 1 will be very light. If you have any questions Please feel free to Call.. I have been through your transition. *************** =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================