Hello,
Chad Taylor has just posted in the Machines & Hardware forum of AmayaUsers
Discussion Boards under the title of Cap Puckering Issues.
This thread is located at
http://www.amayausers.com/discussion/showthread.php?6503-Cap-Puckering-Issues
Here is the message that has just been posted:
***************
Running the same sew out on two machines, an XT and an XTS. The substrates are
both super structured hats, which gives us issues regularly. Regardless, both
machines are running with loose bobbin tension and Actifeed set to 10 on
standard mode. Our XTS is sewing out the cap with nearly no puckering
whatsoever, the XT however is is sewing the image well but is pinching in the
middle and the outsides of front. I made sure I was up to date on maintenance,
and loaded the caps on the hoops with equal tension and backing etc. I cannot
figure out why one is nearly perfect while the other is warping. Other than
the machine difference, anyone have any suggestions I may have overlooked?
***************
===========================================================
The AmayaUsers Mailing List
Website: http://www.amayausers.com
Discussion Board: http://www.amayausers.com/boards
Subscribe/Unsubscribe: http://www.amayausers.com/list
===========================================================