Hello,
levelbest has just posted in the Machines & Hardware forum of AmayaUsers
Discussion Boards under the title of False bobbin break.
This thread is located at
http://www.amayausers.com/discussion/showthread.php?6203-False-bobbin-break
Here is the message that has just been posted:
***************
---Quote (Originally by stargazeremb)---
Hello my Amaya XT will run great and then all of a sudden it will stop and say
bobbin break. I check bobbin which is still attached and then start the
machine again and needle will touch down three times then stop and say bobbin
break. The only way I found to fix this is to shut off the machine and restart
but then after about a half hour it will do it again. Please help!
---End Quote---
At least to get thru today - turn off bobbin detection.
In the OS, Tools > Machine > Enable Bobbin Thread Detection - uncheck.
I find sometimes on certain types of columns on one of my machines - I get this
problem occasionally.
You may also find your acti-feed minimum is set too high and lowering it might
help.
***************
===========================================================
The AmayaUsers Mailing List
Website: http://www.amayausers.com
Discussion Board: http://www.amayausers.com/boards
Subscribe/Unsubscribe: http://www.amayausers.com/list
===========================================================