Hello,
levelbest has just posted in the Machines & Hardware forum of AmayaUsers
Discussion Boards under the title of Help! Machine keeps shutting down.
This thread is located at
http://www.amayausers.com/discussion/showthread.php?6200-Help!-Machine-keeps-shutting-down
Here is the message that has just been posted:
***************
---Quote (Originally by ehendrix24)---
Ok so I tried to change the thread needle from 16 the one I was using and
getting the z axis error message with and I changed to 15 and it stitched
without getting a error message so I'm thinking it may just need the hook
timing reset since it is also done on needle 16
---End Quote---
Doesn't sound like that to me - but here's hoping...
When our motor was failing - there were times when it first started that it
would run ok and then just quit in the middle of a design. It made it
difficult to diagnose. Even walked thru it with John Hansen of Melco trying to
figure it out.
Eventually we came to the conclusion that the motor was toast. Replaced it and
never had the issue again. The second time it happened, I knew pretty well
what the symptoms were.
Anyway, like I said - hope you get it straightened out one way or another.
***************
===========================================================
The AmayaUsers Mailing List
Website: http://www.amayausers.com
Discussion Board: http://www.amayausers.com/boards
Subscribe/Unsubscribe: http://www.amayausers.com/list
===========================================================
