Hello,
Brian A has just posted in the Machines & Hardware forum of AmayaUsers
Discussion Boards under the title of EMT 16 Breaking Needles on caps.
This thread is located at
http://www.amayausers.com/discussion/showthread.php?6190-EMT-16-Breaking-Needles-on-caps
Here is the message that has just been posted:
***************
Just adding my experience...... 2.3" tall might be too tall for that style of
cap (I don't know the make). If the design gets too high on the cap it'll
buckle which'll cause the needle to bend and strike the needle plate. If the
design is too low on the cap, the bill might cause the cap to lift creating the
same situation. I hope you've figured it out
***************
===========================================================
The AmayaUsers Mailing List
Website: http://www.amayausers.com
Discussion Board: http://www.amayausers.com/boards
Subscribe/Unsubscribe: http://www.amayausers.com/list
===========================================================
