This message was posted by HERB on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/ultimatebb.php?/topic/2/40.html#000001 I beleive you are correct in your dimensions, BUT, the a factor in the design size is also the type of cap. There is no way you are going to sew a 3 inch tall design on most low profile caps. It would be tough to get one to work on a mid profile. Scaling in OS is not possible. This should be done prior to sending the design to the machine. =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================