[amayausers.com] Re: Frequent False Bobbin Breaks

This message was posted by Sewfly on AmayaUsers.com. PLEASE DO NOT REPLY VIA 
EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: 
http://www.amayausers.com/boards/ultimatebb.php?/topic/2/1081.html#000009

I'm sorry I didn't go into further detail on the min/max settings.  

If you have your min setting at 6 and your setting should be at say a 3 due to 
the fabric/backing being thin, then you will be feeding too much thread which, 
for me, has been the cause of thread and/or bobbin breaks.  

Likewise, I have seen the autofeed jump up to a 25 or higher and sit there.  So 
by checking the max feed setting (making sure it is in a reasonable zone for 
the fabric) can also keep from getting thread/bobbin breaks from too much feed.

Occassionally, I go to the standard mode to check the system's recommended 
setting for a particular fabric.  From there, I go into settings and adjust my 
min settings 1 or 2 lower than the recommended setting and 5 or 6 higher than 
the recommended for the max setting (assuming there are no seams to sew over).  
And before stitching, I resume the auto mode.

Hope this helps.

Susan

=========================================================== 

The AmayaUsers Mailing List
Website: http://www.amayausers.com
Discussion Board: http://www.amayausers.com/boards
Subscribe/Unsubscribe: http://www.amayausers.com/list

===========================================================

Other related posts: