This message was posted by djames on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/ultimatebb.php?/topic/2/510.html#000001 David, There are a couple of ways you can change the walking stitch length. As you are digitizing a design you would go to the imput tool bar, right click on the walk normal stitch button and input the stitch length that you want. If it is a design that has already been done then go to the project level at the top of your project view, right click, go to properties and change it at the stitch tab. You can also do it at the element level in the project view. Likewise you might want to change it in the lettering properties. There are 2 places in lettering, the stitch length on the lettering tab is for the stitch that DS creates to get from one point to another. The second is in the column tab, and this is for the walk stitch in your underlay. If you go to the Help at the top of your page, go to Contents, Using Design Shop, Orientation, there is a little refresher course on the layout of DS. Thre are tabs & buttons that we don't use all the time and forget what they are for Hope this helps. Debbie =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================