I am a newbie. Just bought a used machine but bought the upgrades for the software. I seem to be doing well in DesignShop. However, I am having trouble in the OS/and the machine. Two problems: a) When I load a design to be stitched out, it loads the design all of the way on the left and thus hits the hoops, thus will not stitch. (I cannot center it.) b) I can not delete the sent design from the work load. When I hit the "x" at the right corner (the means of closing a design), it registers at the bottom that this is to close and give option for saving, but nothing happens. It stays there. I can only close out the whole program (OS). But, when I reopen, that same design comes up again-still off center. Does anyone have suggestions? Bill William A. Griffin Roanoke Bible College Elizabeth City, N. C 27909 252.334.2001 252.335.2321 -home www.roanokebible.edu =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================