[amayausers] Re: Auto Density

Thank you very much for all this information, I will copy it and have.  My copy 
book is getting full from everyone's good idea's and advice.
Ruth
  ----- Original Message ----- 
  From: Ed Orantes 
  To: amayausers@xxxxxxxxxxxxx 
  Sent: Friday, December 30, 2005 2:48 AM
  Subject: [amayausers] Re: Auto Density


  Ruth,
      The two columns of numbers Herb has listed are as he said, the "Auto 
Density" settings he uses.  The first of the two columns of numbers represents 
the column's width measured in "points".  Remember that there are 254 points in 
an inch.  Therefore, if the machine is sewing a very thin column that is about 
10 points wide/across, then the corresponding density setting will be "5.0".  
The larger the column width is, the closer the stitches need to be to insure 
adequate coverage on the fabric.  Hence, as the alternating stitches in the 
column get closer to each other, the density becomes a smaller number.
      I like to use the Auto Density feature when ever I use a real 
fancy-swirly font that has a varied column width through out the entire font.  
Similar to the Diane Font.  Unlike the Block font that has a column width that 
is just about the same the entire way through the alphabet.

      Hope this helps.

  Ed Orantes
  504-258-6260


    -----Original Message-----
    From: amayausers-bounce@xxxxxxxxxxxxx 
[mailto:amayausers-bounce@xxxxxxxxxxxxx]On Behalf Of HK Acree
    Sent: Tuesday, December 27, 2005 5:19 PM
    To: amayausers@xxxxxxxxxxxxx
    Subject: [amayausers] Re: Auto Density


    Ruth,
    These setting are a little more dense than the default settings provided by 
Melco. When you go to column properties there is a little button next to the 
check mark for auto density. Select that button and your auto density settings 
appear. You can then change them to something else. Changing mine to these 
settings made auto density work better.


    Herb 
      ----- Original Message ----- 
      From: Ruth Williams 
      To: amayausers@xxxxxxxxxxxxx 
      Sent: Tuesday, December 27, 2005 3:07 PM
      Subject: [amayausers] Re: Auto Density


      Ok Herb, you have lost your dear friend on the other side of the river.  
Explain yourself please.

        ----- Original Message ----- 
        From: HK Acree 
        To: amayausers@xxxxxxxxxxxxx 
        Sent: Friday, December 23, 2005 8:27 AM
        Subject: [amayausers] Auto Density


        Here are the Auto Density settings I use. The came from the High 
Priestess of Digitizing.

        10        5.0

        20        4.2

        30        3.9

        40        3.7

        50        3.5

        60        3.3       

        70        3.1       

        80        3.0       

        90        3.0       

        100     3.0

        Herb

Other related posts: