Bill, Make sure you change all 3 of them! I believe they are under rated for the job....that's why you should use 1 watt replacements Jeff Stielau Shoreline Electronics Repair 125 Beech Tree Lane Westbrook, CT 06498 860-399-1861 860-664-3535 (fax) jstielau@xxxxxxxx ----- Original Message ----- From: "Bill S" <billans@xxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Sunday, May 19, 2002 10:06 PM Subject: [TechAssist] Re: Zenith Z56Z83D7 Bowed lines fixed, but now smeared picture > > Hi > Found the open 120 K resistor on the crt module. What causes these 120 K > resistors to go bad???? Is it the white glue that Ron mentioned in this > post? > Bill Sorensen > New Life Video & Audio > billans@xxxxxxxxxxxx > - - - - - - - - - - - - - - - - - - - > > ----- Original Message ----- > From: "Ron Miller" <rlmbkm@xxxxxxxx> > To: <techassist@xxxxxxxxxxxxx> > Sent: Sunday, May 19, 2002 3:17 PM > Subject: [TechAssist] Re: Zenith Z56Z83D7 Bowed lines fixed, but now smeared > picture > > > > > > Check 120k resisters on each crt pcb,the ones that connect from 15K 3 watt > > to base bias resisters.Remove one end from pcb,also 110 Kohm off horiz > > output,has white glue near/on it.HTH > > Country TV > > Ron Miller > > 484 FM444 S. > > Inez,TX 77968-5002 > > V.(361)782-6419. F.(361)782-9149 > > > > ----- Original Message ----- > > From: "Bill S" <billans@xxxxxxxxxxxx> > > To: <techassist@xxxxxxxxxxxxx> > > Sent: Sunday, May 19, 2002 7:20 PM > > Subject: [TechAssist] Zenith Z56Z83D7 Bowed lines fixed, but now smeared > > picture > > > > > > > > > > Ugh! > > > I had worked on this a month ago with the two resistors being opened or > > > changed in value. R3243 was open. R3244 checked Ok. The customer > called > > > and told me that the set was working good except that the picture was > > going > > > goofy. He brought it in here and I would say that there is a smearey or > > > smudgy picture. The faces look green. Tint control does nothing. I > have > > > gone over all the connections to see if something came loose and so far > > > nothing. Could the focus/splitter module have gone bad just > > "coincidently"? > > > Or are there other things going on? > > > Thankyou for your help > > > > > > Bill Sorensen > > > New Life Video & Audio > > > billans@xxxxxxxxxxxx > > > - - - - - - - - - - - - - - - - - - - > > > > > > > > > > > > > > > ------------------------------------------ > > > To REMOVE your email address, click here: > > > http://www.tech-assist.org/unsubb.html > > > To CHANGE your email address, click here: > > > http://www.tech-assist.org/change.html > > > ------------------------------------------ > > > ***NEW*** Tips Added Instantly!!!*** > > > Submit Repair Tips here: > > > http://www.tech-assist.org/secure/tip/ > > > > > > > > > > > > > ------------------------------------------ > > To REMOVE your email address, click here: > > http://www.tech-assist.org/unsubb.html > > To CHANGE your email address, click here: > > http://www.tech-assist.org/change.html > > ------------------------------------------ > > ***NEW*** Tips Added Instantly!!!*** > > Submit Repair Tips here: > > http://www.tech-assist.org/secure/tip/ > > > > > > ------------------------------------------ > To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html > To CHANGE your email address, click here: > http://www.tech-assist.org/change.html > ------------------------------------------ > ***NEW*** Tips Added Instantly!!!*** > Submit Repair Tips here: > http://www.tech-assist.org/secure/tip/ > > ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.tech-assist.org/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/