That touch pad is NLA and is known to go bad,as for the voll problem seems that increasing the sound with a remote one had to push the voll up button ( on remote) repeatley to get it louder.HTH Country TV Ron Miller Inez, TX. 77968 ----- Original Message ----- From: "Gary McCartney" <gary@xxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Friday, February 25, 2005 9:39 PM Subject: [TechAssist] Re: Zenith TV SD5729W mod. 9-519-1 -touch pad doesn't work > Max, I'm not sure we are talking about the same part here. I am asking > how to get the touch pad apart on the flip down door. > > Here is a pic of it: > > http://www.number63.ca/zenithdoor.jpg > > Do you have one like it? I'm not familiar with these. Is it the touch > pad that is most likely the problem, or is data on the main board not > getting to the micro a common thing? > > > > > Gary McCartney > > McCartney Electronics > Guelph Ontario Canada > Est. 1984 > email: gary (at) number63.ca > > > > > > > > > Old TV Man wrote: >> Gary - that control board should come out after removing 2 or 3 screws >> frim the back. It should also have a part # on it. >> I have some of he old control boards if you find the #. >> >> Max Bonnell >> Bonnell TV >> Robinson, IL >> >> Sender: techassist-bounce@xxxxxxxxxxxxx From: >> gary@xxxxxxxxxxx(Gary=A0McCartney) Date: Fri, Feb 25, 2005, 3:50pm >> (CST+1) To: techassist@xxxxxxxxxxxxx Subject: [TechAssist] Zenith TV >> SD5729W mod. 9-519-1 -touch pad doesn't work Reply=A0to: >> techassist@xxxxxxxxxxxxx >> >> I have this Zenith TV SD5729W with module 9-519-1. The touch pad inside >> the pull down door on the front doesn't work. Set won't start and none >> of the buttons work. I can operate the set with a universal remote >> although it seemed like I could only raise the volume a bit and max. >> level is low. >> >> Customer said that someone let water run into TV. He wasn't sure if it >> was down the face of the tube or not. I haven't seen any sign of water >> in the set. >> >> Is there any way to clean the keypad contacts? If so, how do you even >> remove the door to work at it or take the keypad apart? Or is there more >> likely a problem on the board leading to the micro? >> Thanks for any help. > > > ----------------------------------------------------------------------------- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ > ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/