Phil that's why I don't try rebuilding those. I tied to rebuild one and I ended up with a similar problem. Never did fix the board sent it out and it's been gone over a year. Al Marquardt ampm@xxxxxxx Al Marquardt Electronic Repair 206 W Main Girardville Pa. 17935 ----- Original Message ----- From: "Phil Bader" <tjanphyl@xxxxxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Wednesday, November 10, 2004 3:13 PM Subject: [TechAssist] Zenith PVY6067DT rebuilt 9-1674(dead) played OK 3hrs,bowed,then black > Try to put all that in subject line! > originally was dead with the HOT, diode,etc on the 9-1674 deflection > panel bad. Rebuilt board, and it ran good for several days. Reassembled > it and played 3 hours OK. Looked up and saw the picture narrow from top > and bottom with a top and bottom bow. Like an "eye" shape. Powered it > off, then after a few minutes, when I turned it on again the HV came > up, CRT filaments glowed, sound there but no picture. All 3 CRT black. I > assume it went into safety mode and blanked the CRTs. I changed the > convergence module 9-1690 (simply because I had one and the narrow > distorted display could be this module maybe) but the same thing after > installation > Maybe vertical... > Need some input here. > End of my rope here... > Phil Bader > > -- > > Philip Bader > Jan Phyl TV Inc. (estab. 1976) > 3420 Recker Hwy. Winter Haven, Fl. 33880 > Fax (863) 299-8821 > email: tjanphyl@xxxxxxxxxxxxxxx > > > > ----------------------------------------------------------------------------- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ > > ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/