Peter, Replace the 2SD2627 with a beefier output. The 2SD1879 works nice. PC board has the holes to accommodate. Also , the shut down problem is caused by R520 Increased in value Bz210009 (0.82 Ohm 1watt) Jeff Stielau Shoreline Electronics Repair 125 Beech Tree Lane Westbrook, CT 06498 860-399-1861 860-664-3535 (fax) jstielau@xxxxxxxx ----- Original Message ----- From: "Peter oliver" <oliver_peter1@xxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Sunday, June 30, 2002 11:17 AM Subject: [TechAssist] Toshiba TV-VCR MV19K2R Blew H-out goes into shutdown > > Toshiba MV19K2R (MFD Sept 2000 UL code # 289X Orion? (emerson)) > Blew Horz out (TO220 case) subbed 2SD1880 (for trial) comes on for long > enough for picture and run a couple of min then shutdown, replaced > regulator, no effect.(This one has been on the back burner for a while > trying to get info) > > > Peter > Tucson Radio TV > > > _________________________________________________________________ > Chat with friends online, try MSN Messenger: http://messenger.msn.com > > ------------------------------------------ > To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html > To CHANGE your email address, click here: > http://www.tech-assist.org/change.html > ------------------------------------------ > ***NEW*** Tips Added Instantly!!!*** > Submit Repair Tips here: > http://www.tech-assist.org/secure/tip/ > > ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.tech-assist.org/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/