Leonard,not sure on this model,but on the newer units,the TZ50V61,after completeing the convergence adj.,you have to press #7 to enter the adjustments & #7 again to return to normal picture.These are the TAC9951 chassis.........Don..... HARTS-TVCR''ASC'' 9 Robert St.,Oromocto,NewBrunswick,Can E2V 3N2 Tel#506-357-9785,Fax#506-357-6010 hartstv@xxxxxxxxxxx ----- Original Message ----- From: "Leonard G. Caillouet" <lcaillo@xxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Tuesday, September 17, 2002 6:20 PM Subject: [TechAssist] Toshiba CX27F60 27 in TV, TAC9605, EEPROM memory > > Is there some procedure that I am missing to save parameters in the service > menu? I have a manual from a very similar model and it just says to hit the > power button to exit the service mode with no discussion of a save > procedure. When we do this it does not keep the parameters. Changed the > EEPROM and no change. > > Any suggestions? > > Leonard G. Caillouet > Service Manager > Electronics World > Gainesville, FL > 352-332-5608 > 352-332-5668 (fax) > > > ------------------------------------------ > To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html > To CHANGE your email address, click here: > http://www.techassist.net/forms/change.html > ------------------------------------------ > ***NEW*** Tips Added Instantly!!!*** > Submit Repair Tips here: > http://www.tech-assist.org/secure/tip/ ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/