This may be a longshot but this is an excerpt from another post: Toshiba 36A40 pie crusting problem was flyback as we suspected if you see this and everything else looks ok its the flyback. Bob Waterman, CET® #RI-28 Master Technician License #9109 Service Manager / Parts Manager Gemini Computer, TV, & Security Alarms (508)695-7302 (508)695-7769 FAX geminitv@xxxxxxxxxxx ----- Original Message ----- From: "becyn" <becyn@xxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Wednesday, December 15, 2004 2:34 PM Subject: [TechAssist] TOSHIBA 27A44, raster pulled in horiz, ratty in both v&H > Hello all, > tough one here... > > This toshiba has a pulled in raster in the horiz about an inch on > each side, but more or less straight, so i don't think it's pin. B+ is > at 124v (low?) but clean. > Vertical is full size but has an occassional bounce. Horiz raster is > very ratty(jagged), as if the SMPS filter cap was bad and introducing > noise , however the H out collector wf is clean and HV is at 25KV. > > The software H size adjust works and allows full size restoration, but > the raster still looks like hell. > H yoke rings out at 15 on my antique VA 62. > Could it be an arcing yoke??????? > > Jim McVey > McVey Alltronix > 327 Broadway > Newburgh N.Y. 12550 > > *NOT* a NESDA member > Factory authorized > service for over 20 > major brands. > 845 561 8383 > > -------------------------------------------------------------------------- --- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ > ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/