When set is first turned on the picture is very bright and looks almost negative. After about 2 minutes it gradually darkens until it stops below normal brightness viewing level. If you turn off the set for 2 seconds and turn it back on the cycle starts all over again. The kb,kr,kg all read about 114volts at turn on and gradually increase to about 189 volts when the screen is darker. G2 is consistent at 285volts. The r,b,g, feed from the jungle ic starts at 3.2 volts and gradually decreases to 1.5 volts at its darker point. The 200volt supply also remains at 200volts always. The 9volt stays at 9volts. The ik goes from 3.5 to about2.4volts as it gets darker. I changed the jungle ic of course- made no difference at all. Any of you Sony all-stars seen this? Thanks Mike Video Center ttkirkpat@xxxxxxx ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.tech-assist.org/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/