I will check. Since then, I ordered a pair of STK converg.chips. Thought I would install and see... Phil Bader Intrepid Video Support wrote: >Phil, >Did you see this, closest I can find: >Sony\KP43T70\Picture distorted (snake skin type picture)\\\\IC206 on A >board\\\\\\\\ >Jeff >-- >Intrepid Video TV/VCR Repair >263 S Front St, Steelton PA 17113 >717-939-7708; (F) 717-564-4952 >www.intrepid-video.com www.tech-repair.net >----- Original Message ----- >From: "Phil Bader" <tjanphyl@xxxxxxxxxxxxxxx> >To: <techassist@xxxxxxxxxxxxx> >Sent: Thursday, June 24, 2004 10:51 PM >Subject: [TechAssist] Sony KP43T70 (RA3) bowed& pulled in sides after repl. >HOT,fly,etc > > >Was dead. Had HOT shorted. >ordered new HOT, fly, HV block , C522 scan cap, L503 (cap, coil changed >due to past histories). Now powered up with the mentioned pix pulled in >from sides and bowed. >next to fly found open R595 (.47 ohm) Replaced it with a bit higher >wattage, powered up, IC 1504 (8 pin op amp C4558) smoked. Replaced >IC1504, still same. Need input here! >Seems like absolutely no convergence. All the pico fuses are OK. Just >found there are no supply voltages to convergence chips. >Will advise. In mean time, suggestions? > >Thanks, >Phil Bader > > > -- Philip Bader Jan Phyl TV Inc. (estab. 1976) 3420 Recker Hwy. Winter Haven, Fl. 33880 Fax (863) 299-8821 email: tjanphyl@xxxxxxxxxxxxxxx ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/