Spindle height, clamping problem, etc? Is the noise from the disc itself or the servos working to keep up? Leonard G. Caillouet Electronics World Gainesville, FL 352-332-5608 352-332-5668 (fax) ----- Original Message ----- From: "Keith Trumbla" <ktrumbla@xxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Friday, November 14, 2003 4:22 PM Subject: [TechAssist] Sony CFD-Z130 CD problem > I have changed both the laser and spindle motor in this unit. It will sometimes play, but it is very noisy when it reads the disc. I have tried lowering the focus and tracking gain to no avail. I have tried a second laser as well. When the disc plays, it plays fine. You can remove the disc and re-insert it and then it will decide not to read TOC even though it just played it seconds before. Any ideas ? > TIA > Keith Trumbla > BEMelectronics.com > Suite 212 - 530 Century St > Winnipeg Canada > R3H 0Y4 > Ph.204.775.2875 Fax 204.774.9192 > **************************************************************************** * > Classifieds! Buy or Sell! > http://sell.tech-assist.org > The Tech Address Book: > http://www.tech-assist.org/secure/tip/contact.htm > Add a Repair Tip Here, or Change/Remove your Email Address: > http://www.tech-assist.org/secure/tip/main.htm > Lost Password: > http://www.tech-assist.org and select "Lost your Login Info?". > Email Archives: > //www.freelists.org/archives/techassist/ ***************************************************************************** Classifieds! Buy or Sell! http://sell.tech-assist.org The Tech Address Book: http://www.tech-assist.org/secure/tip/contact.htm Add a Repair Tip Here, or Change/Remove your Email Address: http://www.tech-assist.org/secure/tip/main.htm Lost Password: http://www.tech-assist.org and select "Lost your Login Info?". Email Archives: //www.freelists.org/archives/techassist/