What is the regulated voltage to the output? Is it too high? Check caps and diodes on the collector of the hor output. At 06:35 PM 10/10/02 -0700, you wrote: >I'm having a terrific problem with a Sanyo DS31590 that has too wide of >a picture. The width control has some effect but not enough to mack the >picture normal. I found a horz lin coil that rang funny and sure enough >when the new one came in today it rang differently than the old one. If >I leave on the set for about 10 minutes the output will blow. I've used >all original parts from SFS corp and still same problem. Any know what i >might be missing. I've checked all regulator, horizontal and all >resistors caps and transistors in both circuits. Can't find anything >obviously wrong. I even tried subbing yoke with another 31" out of >another set. What am I missing. I looked on Repair World site and >another fellow is having iditicial problem but isn't receiving any >replies. > >-- >Ralph Dorsey >Atlas TV Inc >3945 s 76th St. >Milwaukee Wi 53220 >414-545-2303 > > >------------------------------------------ >To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html >To CHANGE your email address, click here: > http://www.techassist.net/forms/change.html >------------------------------------------ >***NEW*** Tips Added Instantly!!!*** >Submit Repair Tips here: >http://www.tech-assist.org/secure/tip/ James M. Knoble 2303 Pleasant Valley Road Fairmont, WV 26554 jmk1938@xxxxxxxxxx Phone 304-366-1938 Fax 304-367-8965 ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/