Look at the power board mounted above the Convergence board. find the 6 pin connector and measure to chassis ground for + and - 15 volts, + and - 45 volts. If any of these missing replace the corresponding rectifier diode. If all missing except the +23 volts, after unplugging AC power remove convergence yoke plugs on the side of the convergence amp board and re-apply power. Did the + and - supplies return? If so troubleshoot the convergence amp board BUT don't rule out the power supply board. I have seen the +- supplies appear OK with the yokes loose but still a bad power supply Robert tvservice@xxxxxxxxxxxxx H & H Electronics Inc ----- Original Message ----- From: "Eric Manuel" <tvman@xxxxxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Tuesday, October 05, 2004 3:09 PM Subject: [TechAssist] Rca Projo P52812BL-Ch# PTK195AB pin cushion out > Hi need some help on this one .Frst one that I seen pic > bowed side and top.Also do this set have auto convergence > I need a lot of info on this one.Thanks Eric > E M Electronics > Deer Lake Nfld > Canada > tvman@xxxxxxxxxxxxxxx > > -------------------------------------------------------------------------- --- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/