Unit will not power up.Have narrowed it down to the Gemstar module''I think'' U14104=12volt reg,has no i/p on pin 1.Q14104 & q14105 smd are good.The RUN/STBY for this cct comes from U13101 pin 19 in the Gemstar module.Is there a way to reset this module? I checked on Tritronics & the part # they give is 244160,which they say is N/A,use sub # 253023.My module has 2 ribbon wires,so not sure if this is the module Tritronics is referring to.Every thing else in this unit seems ok,HOT B+ is 138vdc.The 16vdc source which goes to the emmiter of Q14104 is there,but is not turning on from Q14105[smd] via pin 19 of U13101.So can this module be reset,repaired or do we just replace it & which is the correct # for it.It's hard to beleive the 244160 is N/A on a 3 year old set....TIA.... Don of HARTS-TVCR-ASC 9 Robert St,Oromocto,NB,Canada,E2V3N2 Tel-506-357-9785,Fax-506-357-6010 hartstv@xxxxxxxxxxx ***************************************************************************** CHECK OUT THE NEW CHATROOM! Just login and click on chat! http://www.tech-assist.org/secure/tip/main.htm The Tech Address Book: http://www.tech-assist.org/secure/tip/contact.htm Add a Repair Tip Here, or Change/Remove your Email Address: http://www.tech-assist.org/secure/tip/main.htm Lost Password: http://www.tech-assist.org and select "Lost your Login Info?". Email Archives: //www.freelists.org/archives/techassist/