Thanks to those who offered help on this bear. This one had intermittent power. Would try to turn on three times then stop. Sometimes it would power up with vertical collapse. I t was very intermittent and stopped showing the problem when dissassembled. The solution was to resolder connections to one of the modules on the power board (the one near the wiring harness to the vertical module). This chassis is notoriously hard to work on and there was no way to see the connections without removing the module from the power board. If any of you run into one of these make sure that you estimate high. Just getting to the power board is a chore. Leonard G. Caillouet Service Manager Electronics World Gainesville, FL 352-332-5608 352-332-5668 (fax) ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.tech-assist.org/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/