Robert,pull the vertical yoke winding, if your 13v supply line returns to 13 volts,take a heat gun and heat up C14501 and C14503 and see if the vertical returns or partially returns, if it does try removing these 2 caps and then scrape off ALL the glue that holds them to the board. Check the board traces with a magnifying glass and verify their still good, then check the caps, sometimes their still good, othertimes their not, this should fix your set. Larry Eastman American TV& Electronics Crystal River, Fl. 34428 tvservice wrote: > Hey all you RCA techs, > I know whats good on this chassis but don't know why I have no vert > deflection. I have replaced U14501, U13201, RN14501, U12601, CR14501 > I have .5vpp (thats point 5vpp)at U12601 pin 15 (should be @2.4vpp), U14501 > pin1 +15v, pin 7 +14.8v, pin 2 +26v, pin 6 +25.4v, pin 5 +26 v, pin 3 +1.4v > My + 13 volt supply from flyback CR14703 is +21 volts, all other flyback > source voltages OK > What am I missing? > tia > Robert > tvservice@xxxxxxxxxxxxxxxxxxx > H & H Electronics Inc > > > ------------------------------------------ > To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html > To CHANGE your email address, click here: > http://www.techassist.net/forms/change.html > ------------------------------------------ > ***NEW*** Tips Added Instantly!!!*** > Submit Repair Tips here: > http://www.tech-assist.org/secure/tip/ > > > > -- Larry Eastman American TV & Electronics Crystal River, Fl. http://www.tvjunkyard.com ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/